THE BEST INSPIRATION


Panel-jig-for-table-saw, learn how to make a raised panel jig for your tablesaw. wood magazine's jim heavey shows you how this jig keeps your stock securely fixed for repeatable and accurate cuts.. Rather than buy a set of raised-panel router bits, i use this tall fence on my tablesaw. it’s simply a plywood box that slides on the rip fence. i use two bar clamps to hold my 3/4-in., the top of the jig is adjustable so that panels of any thickness can be cut using the same block. a notch at the back of the top pushes the panel through the blade. the outside leg of the jig is longer so it can ride in a miter slot in the saw table. this keeps the block aligned with the fence..

With the sled's guide bar in your tablesaw's miter-gauge slot, crank the saw blade up to full height. run the sled through the blade, slicing off the extra 1 ⁄ 8" from both the base and the fence.. you now can cut with confidence by aligning the cut line on your workpiece with the edge of the fence., this is a full recap of 12 great tablesaw jigs from wood magazine's jim heavey. cross cut sled, zero clearance inserts, miter gauge extension, auxiliary rip fence, raised panel jig, tenoning jigs ....

Crosscutting wider panels to trim them down to size or to square them up can be a frustrating experience, unless you have something like a track saw set up especially for that task., you can also make a jig to turn your table saw into a jointer. now this jig from jay bates at www.jayscustomcreations.com is a great multipurpose table saw jig, which lets you joint the timber edges. for more details on this jig, you can find it here. jay bates - woodworking videos.

To locate the guide bar, measure the distance from the right edge of the left-hand miter-gauge slot to the saw blade, then add 1/4″ – this jig rides to the left of the blade. once the guide bar is attached, the additional 1/4″ allows you to trim a straight edge that’s aligned with the table-saw blade., build these simple table saw sleds and make perfectly square cross cuts and flawless 45-degree miter cuts in both small and wide boards. you only need a 4x4 sheet of 1/2- or 3/4-in. plywood, particle board or mdf, some glue and a few hours time. if you own a table saw, you know it works great for ...